HEYLOVE. Frame builder Gel, DREAMY, 30 ml. Universal building gel

Modeling gel of medium creamy consistency with fine shimmer that gives the coating a deep, delicate glow. The material easily spreads, self-levels, and helps form a smooth, even surface with minimal filing.

Due to the balanced combination of strength and elasticity, the gel holds its shape well, maintains coating stability, and ensures comfort in the master's work.

Advantages:

• Almost odorless;
• Medium creamy consistency;
• Self-leveling;
• Does not burn during polymerization;
• Elastic in a thin layer - reduces the risk of lifting near the cuticle;
• Hard with present cushioning in a 1 mm thick layer - holds shape, resistant to chips;
• Passed CPNP notification
• HEMA-free, TPO-free.

Video: https://www.instagram.com/p/DfPTbmTIcKy/

Characteristics:

• Heating during polymerization is moderate, not exceeding 37 degrees;
• Dispersion: moderate sticky layer;
• Elasticity: moderate;
• Hardness: high;
• Polymerization: 60-120 seconds in an LED lamp 48W;

Purpose:

• For sculpting on upper and lower forms;
• Shape restoration, strengthening;
• Reconstructions in the "sidewall" technique;
• No-fill extensions;

1. Prepare the nail plate mechanically (180 grit file or 100 grit buffer).
2. Degrease the nails, paying attention to the cuticle area and side sinuses.
3. Apply a dehydrator and let dry for 30 seconds.
4. Apply the base with rubbing movements and level the surface. Cure for 30 seconds.
5. Press the pump and squeeze out the required amount of material.
6. Apply Frame gel in an architectural layer or place it on an upper form or a lower form (depending on the technique).
7. Polymerize each nail in the lamp for 30 seconds, then both hands additionally for 1–2 minutes.
8. Remove the sticky layer and perform a surface filing if necessary.
9. As the final layer, apply a top coat (top). Cure for 1-2 min.
10. Using a carbide bit file out the natural nail from below in the free edge area.
11. Carefully sand the edge with a buffer to avoid damaging the coating surface.
    Wipe with a damp cloth to remove dust and apply cuticle and hand care products. Ready!

Manufacturer: TM "HEYLOVE"

Country: Ukraine

Composition (INCI): Acrylates Copolymer, Hydroxypropyl Methacrylate, Trimethylbenzoyl Ditolylphosphine Oxide, Silica.
May Contain [+/-]: CI 77499, CI 77891, CI 77491.

Attention! To avoid unwanted polymerization of the material during work, testing, or content shooting, keep the open bottle or brush as far away from daylight (especially direct sunlight) as possible. Please also note that even in cloudy weather, clouds transmit a large amount of ultraviolet radiation sufficient for the material to start polymerizing. When painting tips, we recommend holding the working side of the UV lamp away from the master. If you hold the switched-on lamp with the light towards the master, unwanted polymerization of the material on the brushes and necks of open bottles may occur.

Note: all documents are in the attached files!