HEYLOVE. Frame builder Gel with Pump, TOTAL MILKY, 30 ml, universal builder gel with pump, milky

FRAME gel - universal builder gel in 13 shades

Packaged in a jar with a pump for dosing the gel.

TOTAL MILKY - milky.

Video (material overview and packaging instructions) at the link: https://www.instagram.com/reel/DDjuzN5tvVi/?igsh=YXAwcGZ1MjFmaTJl

Features:

• for modeling, correction, strengthening, extension without filing;
• medium consistency, closer to liquid;
• self-leveling;
• in a thin layer - elastic, and in a thick layer holds the arch and does not deform;
• creates a durable coating resistant to chips;

How to use:

1. Sand the nail plate with a 180 grit file or a 100 grit buffer.
2. Wipe off dust with a degreaser, especially under the cuticle and in the side sinuses.
3. Apply dehydrator and wait 30 seconds for it to evaporate moisture.
4. Using rubbing motions, apply a primer layer of Rubber base and add a little more base to create a smooth surface. Cure for 30 seconds.
5. Press the pump and dispense the required amount of material.
6. Apply Frame gel in an architectural layer or place it on a top form or bottom form (depending on the technique).
7. Cure each nail for 30 seconds, then at the end put both hands again for 1-2 minutes.
8. Remove the sticky layer from Frame gel and perform surface filing if necessary.
9. Apply No Sticky or Dark Story top and cure for 1-2 minutes.

Manufacturer: TM "HEYLOVE"

Country: Ukraine

Ingredients (INCI): Acrylates Copolymer, HEMA, Ethyl Trimethylbenzoyl Phenylphosphinate, Hydroxycyclohexyl Phenyl Ketone, Pigments. May
Contain: Cl 77499, Cl 77891, CI 15850, Cl 45380, Cl 47005, Cl 15510

Attention! To avoid unwanted polymerization of the material during work, testing, or content shooting, keep the open bottle or brush as far away from daylight (especially direct sunlight) as possible. Also, please note that even in cloudy weather, clouds transmit a large amount of ultraviolet radiation, which is sufficient for the material to start polymerizing. When painting tips, we recommend keeping the working side of the operating UV lamp away from the master. If you keep the lamp turned on with the light facing the master, unwanted polymerization of the material on brushes and necks of open bottles may occur.

Note: all documents are in the attached files!