ADORE. One Drop Gel, 30 g, #06, Rose water. Builder gel, milky with a pink undertone

Builder gel in a jar with a vacuum pump one Drop Gel №06 - milky with a pink undertone

one Drop Gel - medium-thick camouflage gel for building, strengthening, and correcting the architecture of nails of medium and above medium length.

Used for:
- building on upper and lower forms
- strengthening and correcting nail architecture as a mono-product and in combined techniques with harder polymer materials

Advantages of one Drop Gel:
+ convenient medium-thick consistency
+ cold polymerization
+ natural shades
The main advantage is excellent self-leveling.

The gel has medium pigmentation; the natural shade of the gel camouflages the transition from the natural nail to the artificial one, adapting to the color of the nail plate.
Convenient to use and store thanks to the vacuum dispensing system: one press = one drop. The drop volume is adjusted by the force of pressing the pump.

Hardness: high.
Viscosity: medium.
Plasticity: low.
Density: medium.
Pigmentation: medium.

! Please note that before first use, you need to remove the transparent protective silicone cap from the pump !

Application technology:
0. Prepare the nail plate: perform a manicure, give the desired shape to the free edge of the nail.
1. Degreasing: mechanically (using a buffer) and chemically (using PREP&FINISH and a lint-free wipe) degrease the nail plate
2. Dehydration: apply NAIL FRESHER to the entire nail, allow to air dry until a whitish tint appears on the surface of the nail plate
3. Bonding: if using adhesive base PRO BASE-BOND, skip this step
4. Base layer: apply a primer even layer of the base coating PRO BASE-BOND, thoroughly covering the side walls and free edge. Polymerize the base coating in a UV lamp for 2-3 min, in an LED lamp for 60 sec.
5. Strengthening: with a gel brush, apply a rubbing layer of gel over the entire surface of the nail plate, leaving 1mm from the cuticle. On the uncured gel, apply a second leveling layer, following the basic principles of modeling with hard materials. Polymerize in a UV lamp for 2-4 min, in an LED lamp - 90 sec.
Remove the dispersion layer using PREP&FINISH and a lint-free wipe. Use a 150/180 grit nail file to perform a step-by-step filing of the shape.

PRO tips:
- to make material application easier, you can use upper forms or gel tips
- to prevent lifting from the free edge, we recommend filing the natural nail from the inside by 1-2mm.

Building: prepare / install forms on each finger one by one. Apply a thin underlay of the desired length and shape directly onto the lower or upper form, then model the nail architecture with gel. To create an arch, you can pinch the gel at 7-12 seconds, depending on the type and power of the lamp. Then place the nail in the lamp until the gel is fully polymerized: 60 seconds in an LED lamp, 3-4 minutes in a UV lamp.
Remove the dispersion layer using PREP&FINISH and a lint-free wipe. Use a 150/180 grit file to perform a step-by-step filing of the shape.

PRO tip: apply the gel leaving a minimum 1mm gap from the cuticle to avoid material lifting in that area

Brand: ADORE 
Volume: 30 g