LUNAmoon. Premium Builder Gel #02 Milky, 100 ml, builder gel, milky

Classic Premium Builder Gel – a polymer light-curing material that, due to its strength, allows significant lengthening of the nail plate. It contains photoinitiators that start the polymerization process when the material is exposed to ultraviolet light of a specific wavelength.

Features:

• Acid-free.
• Has cushioning, does not crack upon impact.
• Medium consistency.
• Medium pigmentation, covers the free edge.
• Suitable for the "no-filing extension" technique.
• Suitable for extension on "top forms".
• Does not cause burning in the lamp.
• Becomes thicker in cold, thinner in warmth.
• Thixotropic – becomes thinner when moving the brush during work.
• Can be additionally heated to make the gel thinner.
• Hard at 1 mm thickness. If thickness is less than 1 mm, it may bend slightly, but this does not affect wear.
• No shrinkage and holds the arch well.
• Requires an underlay of Rubber Base.
• Wavelength for polymerization 365-405 nm.
• UV/LED lamp power 36-48W.
• Allowable coating thickness 0.5 mm at the edge / 1 mm at the apex.
• Full polymerization 120 seconds.

Application method:

STRENGTHENING

1. Removal.
2. Do not file the nail shape or leave 2 mm length, which we will remove after leveling.
3. With a 220 grit nail file, file without strong pressure on the nail from above, lifting the scales of the nail plate, or use a 100 grit buffer.
4. Do a manicure.
5. If working with removers, wash hands with soap after working with them.
6. Degrease the nail using Nail Prep LUNAmoon. Do two passes. Use 4 wipes (1 wipe per 5 fingers). First pass: wipe the nail surface. Second pass: take an orange stick, place a wipe on it and wipe everything in the cuticle area and sinuses.
7. Use primer optionally, but if the base for underlay has sufficient acidity, it is not needed.
8. It is best to apply the underlay of Rubber Base LUNAmoon with a flat gel brush. Movements should be rubbing. Draw all the sinuses of the nail and cure in the lamp for 60 seconds.
9. Wipe off the sticky layer.
10. Level. If leveling with gel, make an indent of 0.5–1 mm from the cuticle. Cure in the lamp for 60 seconds.
11. File the shape after leveling. This is necessary so that a thickness forms at the edge of the nail that will hold the free edge.
12. If the nail was thin, it may curl, so be sure to file 1 mm of the natural nail from the inside. In this case, there will be no peeling of the material. If the material is hard and the nail is very soft, the nail itself will begin to separate from the hard material from the free edge.
13. After filing, wipe off the stickiness and cover with gel polish.
14. Cover with top. Cure for 120 seconds. After curing, do not wipe with anything, as the shine may be lost.

CLASSIC EXTENSION

1. Removal
2. Shorten the nail length to 1 mm and make a round shape.
3. With a 220 grit nail file, file without strong pressure on the nail from above, lifting the scales of the nail plate, or use a 100 grit buffer.
4. Do a manicure.
5. If working with removers, wash hands with soap after working with them.
6. Degrease the nail using Nail Prep LUNAmoon. Do two passes. Use 4 wipes (1 wipe per 5 fingers). First pass: wipe the nail surface. Second pass: take an orange stick, place a wipe on it and wipe everything in the cuticle area and sinuses.
7. Use LUNAmoon primer.
8. It is best to apply the underlay of Rubber Base LUNAmoon with a flat gel brush. Movements should be rubbing. Draw all the sinuses of the nail and cure in the lamp for 60 seconds.
9. Wipe off the sticky layer.
10. Install the form for extending the free edge of the nail.
11. Apply the shape of the artificial nail with clear gel. Cure for 30 seconds.
12. File the free edge and give the nail the desired shape.
13. Wipe off stickiness and excess dust.
14. Go over again with Rubber Base LUNAmoon on the areas where the file was used. Cure for 30 seconds.
15. Level with gel, place in the lamp and clamp at the 10-15th second. If the gel has strong stickiness or contains glitter, clamp at the 20th second.
16. Finish curing in the lamp for 120 seconds.
17. Wipe off stickiness before covering with gel polish.
18. Cover with top. Cure for 120 seconds. After curing, do not wipe with anything, as the shine may be lost.

Product shelf life: 24 months. Store open for no more than 18 months.

Volume: 100 ml

TPO FREE
(Product photos on the site may differ from the actual product)