ADORE. One Drop Gel, 30 g, Clear. Builder gel, clear

Refill of builder gel for nail extension in a jar with vacuum pump one Drop Gel - clear

one Drop Gel - medium-density builder gel for extension, strengthening, and correction of nail architecture of medium and above medium length.

Used for:
- extension on upper and lower forms
- strengthening and correction of nail architecture as a mono-product and in combined techniques in combination with harder polymer materials

Advantages of one Drop Gel:
+ convenient medium-density consistency
+ cold polymerization
+ natural shades
The main advantage - excellent self-leveling.

The gel has a convenient medium-density consistency, moderate thixotropy, and crystal clarity. It does not run or bubble during application. It absorbs pigments well for creating custom color mixes.
Convenient to use and store thanks to the vacuum dosing system: one press = one drop. The volume of the drop is adjusted by the force of pressing the pump.

Hardness: high.
Viscosity: medium.
Plasticity: low.
Density: medium.

Application technology:
0. Prepare the nail plate: perform a manicure, give the desired shape to the free edge of the nail.
1. Degreasing: mechanically (using a buffer) and chemically (using PREP&FINISH and a lint-free wipe) degrease the nail plate
2. Dehydration: apply NAIL FRESHER to the entire nail, let it air dry until a whitish tint appears on the surface of the nail plate
3. Bonding: skip this step when using the adhesive base PRO BASE-BOND
4. Base layer: apply a uniform priming layer of base coat PRO BASE-BOND, carefully treating the side walls and free edge. Cure the base coat in a UV lamp for 2-3 minutes, in an LED lamp for 60 sec.
5. Strengthening: using a gel brush, apply a rubbing layer of gel over the entire surface of the nail plate with a 1mm indentation from the cuticle. On the uncured gel, apply a second leveling layer, taking into account the basic principles of modeling with hard materials. Cure in a UV lamp for 2-4 minutes, in an LED lamp - 90 sec.
Remove the sticky residue using PREP&FINISH and a lint-free wipe. Using a 150/180 grit nail file, perform a step-by-step filing of the shape.

PRO tips:
- to facilitate material application, you can use upper forms or gel tips
- to prevent peeling from the free edge, we recommend filing the natural nail from the inside by 1-2mm.

Extension: prepare / install forms one by one on each finger. Place a thin underlay of the desired length and shape directly on the lower or upper form, then sculpt the nail architecture with gel. To create the apex, you can press the gel at the 7-12 second mark, depending on the type and power of the lamp. Then send the nail to the lamp for complete polymerization of the gel for 60 seconds in an LED lamp, 3-4 minutes in a UV lamp.
Remove the sticky residue using PREP&FINISH and a lint-free wipe. Using a 150/180 nail file, perform a step-by-step filing of the shape.

PRO tip: apply gel with an indentation from the cuticle of min 1mm to avoid peeling of the material in this area