HEYLOVE. Frame builder Gel, VINTAGE, 30 ml. Universal gel for extension

Modeling gel of medium creamy consistency with fine shimmer, which gives the coating a deep delicate glow. The material spreads easily, self-levels and helps to form a smooth, even surface with minimal filing.

Thanks to a balanced combination of strength and elasticity, the gel holds its shape well, maintains coating stability and ensures comfort in the master's work.

Advantages:

• Almost odorless;
• Medium creamy consistency;
• Self-leveling;
• Does not burn during polymerization;
• Elastic in a thin layer - reduces the risk of lifting near the cuticle;
• Hard in a 1 mm thick layer with cushioning - holds shape, resistant to chips;
• Passed CPNP notification
• HEMA-free, TPO-free.

Video: https://www.instagram.com/p/DfPTbmTIcKy/

Characteristics:

• Heating during polymerization moderate, no higher than 37 degrees;
• Dispersion: moderate sticky layer;
• Elasticity: moderate;
• Hardness: high;
• Polymerization: 60-120 seconds in an LED lamp 48W;

Purpose:

• For modeling upper and lower forms;
• Shape restoration, strengthening;
• Reconstructions in the 'edge' technique;
• No-filing extension;

1. Prepare the nail plate mechanically (180 grit file or 100 grit buffer)
2. Degrease the nails, paying attention to the cuticle area and side sinuses.
3. Apply dehydrator and let dry for 30 seconds
4. Apply base with rubbing movements and level the surface. Cure for 30 seconds
5. Press the pump and squeeze out the required amount of material.
6. Apply Frame gel in an architectural layer or place in an upper form or on a lower form (depending on technique)
7. Polymerize each nail in the lamp for 30 seconds, then both hands additionally for 1–2 minutes.
8. Remove the sticky layer and file the surface if needed.
9. As the last layer apply top coat (top). Cure for 1-2 min.
10. With a carbide drill bit file out the natural nail from underneath from the free edge area.
11. Carefully sand the end with a buffer to avoid damaging the coating surface.
    Wipe with a damp cloth to remove dust and apply cuticle and hand care products. Done!

Manufacturer: TM "HEYLOVE"

Country: Ukraine

Ingredients (INCI): Acrylates Copolymer, Hydroxypropyl Methacrylate, Trimethylbenzoyl Ditolylphosphine Oxide, Silica.
May Contain [+/-]: CI 77499, CI 77891, CI 77491.

Caution! To avoid unwanted polymerization of the material during work, testing, or content creation, keep the open bottle or brush as far from daylight as possible (especially from direct sunlight). Also note that even in cloudy weather, clouds let through a large amount of ultraviolet radiation sufficient for the material to start polymerizing. When painting tips, we recommend keeping the working side of the UV lamp facing away from the master. If you keep the lamp on with the light facing the master, unwanted polymerization of the material on brushes and necks of open bottles may occur.

Nota: todos los documentos se encuentran en los archivos adjuntos!