You Are Cute. 3D Jelly Gel #03, 15 ml. Gel for 3D designs, black

Gel for 3D Volume Designs 3D Jelly Gel — decorative gel with no sticky layer for creating raised elements and performing 3D designs on nails. Thanks to the tube format, the material is easy to dispense and apply directly to the nail.

Features:

• No sticky layer.
• Suitable for linear, dot and raised designs;
• Suitable for shaping designs using molds. 
• Allows creating various volume elements.
• Easily controlled directly from the tube.
• Curing wavelength — 365–405 nm.
• UV/LED lamp power — 36–48 W.

Recommendations for use:

For even curing, we recommend forming elements up to 2 mm thick. To create more volume, we recommend layering the material, curing each layer separately. 

When working with molds, the element can be cured directly on the nail: fill the mold with material, apply it to the nail and cure in the lamp.

For the most precise result, we recommend forming and curing the element separately without removing it from the mold. After curing, remove the finished element, fix it on the nail with Rubber Base and additionally seal with top coat.

Application method

1. Perform standard nail preparation and apply the necessary base depending on the design technique: base coat, gel, gel polish or top coat.
2. Carefully squeeze the required amount of 3D Jelly Gel directly from the tube onto the nail. Using a liner or other tool, form a linear, dot or raised element up to 2 mm thick.
3. Cure in a UV/LED lamp for 120 seconds. After curing, allow the material to cool down.
4. If necessary, cover the design with top coat, especially if powder, color or other decorative elements were applied to the gel surface. Cure the top coat for 120 seconds.

Working with molds
Method 1
1. Fill the mold with material.
2. Apply the mold to the nail and cure in a UV/LED lamp for 120 seconds. Allow the material to cool down, then carefully remove the mold.
3. Always cover the design with top coat for better adhesion and durability. Cure for 120 seconds.

Sposób 2
1. Napełnij mold materiałem i polimeryzuj element, nie wyjmując go z molda, przez 120 sekund.
2. Pozwól materiałowi ostygnąć, wyjmij gotowy element i przymocuj go na paznokciu za pomocą Rubber Base. Polimeryzuj przez 120 sekund.
3. Koniecznie pokryj wzór topem dla pewniejszej fiksacji i lepszej trwałości. Polimeryzuj przez 120 sekund.

Skład: Acrylates Copolymer, Isobornyl Acrylate, Isobornyl Methacrylate, Silica, CI 77491, CI 77492, CI 77891, CI 77007, CI 77266, Ethyl Trimethylbenzoyl Phenylphosphinate.

TPO FREE
(Zdjęcie produktu na stronie może różnić się od rzeczywistego produktu)

Pojemność: 15 ml
Producent: You Are Cute